Kenwood KCA-iP500 Manual Do Utilizador
4
|
KCA-iP500
Connection
iPod
(commercially available)
Rear side of Control unit
KCA-iP500
Conversion box
Conversion box
CD changer input
• For instructions on how to connect KCA-iP500
to Control unit, see the Instruction Manual for
Control unit.
Control unit.
Included parts for installation
• Double-stick tape (45mm X 45mm) ...............................1
Power supply function
KCA-iP500 supplies power to the connected iPod
and charges its battery while playing music.
However, the Control unit must be turned on.
and charges its battery while playing music.
However, the Control unit must be turned on.
Installation
• Install iPod in an appropriate location such as the
glove compartment.
Double-stick tape
(included)
(included)
・ Install the conversion box as far as possible from
the center unit. Noise may be generated during
radio reception.
radio reception.
• Avoid placing iPod where it could fall. The iPod
may interfere with driving operation of the vehicle
resulting in an accident.
resulting in an accident.
• Route and install cables so that they are not
exposed to direct sunlight. Cables exposed
to direct sunlight are deformed and becomes
unusable.
to direct sunlight are deformed and becomes
unusable.
• Avoid installing the conversion box where it may
get wet.
• Secure the cables with commercially available
cable clamps as necessary.
Connection and Setup
KCA-iP500_10_English_r3.indd 4
KCA-iP500_10_English_r3.indd 4
06.6.8 11:58:09 AM
06.6.8 11:58:09 AM