Kenwood KDC-MP4033 Manual Do Utilizador

English

   

|

   

Kenwood disc changers/ CD players released in 
1998 or later can be connected to this unit.
Refer to the catalog or consult your Kenwood 
dealer for connectable models of disc changers/ 
CD players.
Note that any Kenwood disc changers/ CD players 
released in 1997 or earlier and disc changers made 
by other makers cannot be connected to this unit.
Connecting unsupported disc changers/CD players 
to this unit may result in damage.
Set the "O-N" Switch to the "N" position for the 
applicable Kenwood disc changers/ CD players.
The functions you can use and the information 
that can be displayed may differ depending on the 
models being connected.

•  You can damage both your unit and the CD changer if 

you connect them incorrectly.

When you turn on the car heater in cold weather, 
dew or condensation may form on the lens in the 
CD player of the unit. Called lens fogging,  this 
condesnation on the lens may not allow CDs to 
play. In such a situation, remove the disc and wait 
for the condensation to evaporate. If the unit still 
does not operate normally after a while, consult 
your Kenwood dealer.

2WARNING

•  To prevent a short circuit, never put or leave any 

metallic objects (such as coins or metal tools) 
inside the unit.

•  Mounting and wiring this product requires 

skills and experience. For safety’s sake, leave the 
mounting and wiring work to professionals.

2CAUTION

•  Make sure to ground the unit to a negative 12V 

DC power supply.

•  Do not install the unit in a spot exposed to direct 

sunlight or excessive heat or humidity. Also avoid 
places with too much dust or the possibility of 
water splashing.

•  Do not place the faceplate (and the faceplate 

case) in areas exposed to direct sunlight, excessive 
heat or humidity. Also avoid places with too much 
dust or the possibility of water splashing.

•  To prevent deterioration, do not touch the 

terminals of the unit or faceplate with your 
fingers.

•  Do not subject the faceplate to excessive shock, 

as it is a piece of precision equipment.

•  When replacing a fuse, only use a new fuse with 

the prescribed rating. Using a fuse with the wrong 
rating may cause your unit to malfunction.

•  Do not use your own screws. Use only the screws 

provided. If you use the wrong screws, you could 
damage the unit.

If you try to load a 8 cm (3 in.) CD with its adapter 
into the unit, the adapter might separate from the 
CD and damage the unit.

B64-3292-00_00_En.indd   3

B64-3292-00_00_En.indd   3

05.10.7   11:30:04 AM

05.10.7   11:30:04 AM