Kenwood DP-SG7 Manual Do Utilizador
R-SG7/DP-SG7/X-SG7 (EN)
54
Preparation section
Basic section
Application section
Knowledge section
In case of difficulty
Remedy
Cause
Symptom
CD player unit
÷ Place the disc properly, with the
label side facing upward.
÷ Place the disc properly.
÷ Clean the disc referring to “Disc
handling precautions”.
÷ Try another disc.
÷ Refer to “Beware of condensation”
and remove the condensation by
evaporation.
evaporation.
÷ Place a disc in the CD player.
÷ Press the 6 key.
÷ Clean the disc referring to “Disc
handling precautions”.
÷ Try another disc.
÷ Clean the disc referring to “Disc
handling precautions”.
÷ Try another disc.
÷ Install the unit in a place not sub-
ject to vibrations.
A CD is placed in the player but
it cannot be played.
it cannot be played.
Sound is not produced.
Sound skips.
÷ The disc is placed upside down.
÷ The disc position is displaced.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ Dew is condensed on the optics lens.
÷ The disc has not been placed.
÷ The player is not put to the play mode.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ The disc is dirty.
÷ The disc is scratched.
÷ The player is subject to vibration.
)
)
o
o
Q
)
)
o
)
o
o
1.With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape
protection function, and not a malfunction.
2.Do not use longer than 100 minutes tapes, for the tape is too thin and gets easily tangled.
Notes
Notes
Remedy
Cause
Symptom
Cassette deck unit
÷ Use a cassette with an unbroken re-
cording protect tab or block the hole.
÷ Select the source to be recorded
with the input selector key.
÷ Change the tape transport direc-
tion or reverse the tape insertion
orientation.
orientation.
Recording cannot be started by
pressing the record key.
pressing the record key.
o
ª
•
÷ The recording protect tab of the
cassette has been broken.
÷ The TAPE input is selected.
÷ The tape is fully wound to one of
the reels.
Remote control unit
Symptom
Cause
Remedy
Remote control operation is not
possible.
possible.
÷ Batteries are exhausted.
÷ The remote control is too far away
from the system, the controlling angle
is deviated or there is an obstacle in
between.
is deviated or there is an obstacle in
between.
÷ There is no tape or CD set in the
component to be played.
÷ An attempt is made to play the cas-
sette deck which is recording some-
thing.
thing.
÷ Replace with new batteries.
÷ Operate the unit inside the remote
controllable range.
÷ Set a tape or CD in the component
to be played.
÷ Wait until the recording ends.
&
&
&