JL Audio SB-F-TRKCTR3/10W3v3 Manual Do Utilizador
➔
➔
➔
➔
➔
➔
STEP 8: Remove the four screws (two per
side) from the sides of the console.
side) from the sides of the console.
STEP 13: Reinstall the outside console over
the inner console and the Stealthbox with
eight 7mm bolts which were removed in
steps 6,7 and 8. Place the conlose/Stealthbox
back into the truck.
the inner console and the Stealthbox with
eight 7mm bolts which were removed in
steps 6,7 and 8. Place the conlose/Stealthbox
back into the truck.
Cont.
From
age 1
Continued on Page 3 ➔
➔
STEP 9: A large section of the bottom of the
console must be removed. The cut travels
from side to side 3/4” in front of the bolt at
the rear the bottom of the console (point
#1). This cut then angles down to meet the
edge of the bottom rib on the side of the
enclosure (point #2). The cut travels to the
other end of the rib(point #3) and then
angles up the side and across the bottom so
as to meet a point 1/2” inside the bolt at the
front of the bottom of the console (point
#4). The same path is taken on the other side
of the console.
console must be removed. The cut travels
from side to side 3/4” in front of the bolt at
the rear the bottom of the console (point
#1). This cut then angles down to meet the
edge of the bottom rib on the side of the
enclosure (point #2). The cut travels to the
other end of the rib(point #3) and then
angles up the side and across the bottom so
as to meet a point 1/2” inside the bolt at the
front of the bottom of the console (point
#4). The same path is taken on the other side
of the console.
STEP 14: Run speaker wire so that it is
accessible at the front of the enclosure,
connect it to the enclosure and test for
proper operation.
accessible at the front of the enclosure,
connect it to the enclosure and test for
proper operation.
➔
STEP 15: Using an an 18mm socket wrench,
secure the front of the console to the vehicle
with the 18mm bolts removed in Step 1.
secure the front of the console to the vehicle
with the 18mm bolts removed in Step 1.
STEP 16: Using an an 18mm open end
wrench, secure the rear of the console to
the vehicle with the 18mm bolts removed in
Step 4.
wrench, secure the rear of the console to
the vehicle with the 18mm bolts removed in
Step 4.
STEP 17: Snap rear panel (removed in step
4) back unto rear of console.
4) back unto rear of console.
STEP 18: Reinstall cup holders (removed in
Step1).
Step1).
STEP 10: Remove the nine remaining 7mm
bolts to separate the inner console.
bolts to separate the inner console.
STEP 11: Sandwich the Stealthbox between
the two halves of the inner console and
secure using the nine 7mm bolts removed in
step 10.
the two halves of the inner console and
secure using the nine 7mm bolts removed in
step 10.
STEP 12: Glue the two supplied 8”x8” pieces
of carpet to the sides of the inner console
(one per side).
of carpet to the sides of the inner console
(one per side).
➔
➔
➔
➔
➔
➔
➔
4
3
2
1
Bottom Rib