Crown Audio CDI1000 Manual Do Utilizador
CDi Series Power Amplifiers
Operation Manual
page 9
2 Setup
(continued)
Channel 1
2.6.2 Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 2.6.
Typical input and output wiring is shown in
Figure 2.6.
NOTE: Crown provides a reference of wiring pin assignments
for commonly used connector types in the Crown Amplifier
Application Guide available at www.crownaudio.com.
for commonly used connector types in the Crown Amplifier
Application Guide available at www.crownaudio.com.
OUTPUTS: Connect the speaker across barrier-strip
terminals 1+ and 2+.
terminals 1+ and 2+.
IMPORTANT: Set the Bridge/Normal switch in the LCD
screen to “Bridge.” See Section 4.1.5.
screen to “Bridge.” See Section 4.1.5.
NOTE: In Bridge-Mono mode, only the
Channel 1 Level control is functional (unless you
make an alternate selection via the “Y” menu. See
Section 4.1.6.)
Channel 1 Level control is functional (unless you
make an alternate selection via the “Y” menu. See
Section 4.1.6.)
Figure 2.6 System Wiring,
Bridge-Mono Mode