Panasonic VW1 Manual Do Utilizador

4. Dipswitch Settings

After removing the radio from the vehicle, identify the manufacturer of the

radio. Two companies make the radios featured in these VW vehicles. If the

model number sticker is on the side of the radio it is a Delphi brand radio. If

the model number sticker is on the top of the radio it is a Panasonic brand

radio.

For Delphi radios all dip switches must be in the OFF position (up) for

the Neo Gateway to function.

For Panasonic radios only dipswitch #2 needs to be turned ON

(down), the rest must be OFF (up) for the Neo Gateway to function.

5. Installation

Before installing the Neo Gateway, be sure you have correctly set

the dipswitches according to section four.

NOTE: DO NOT disconnect the wiring from the “passenger airbag

light” on the dash bezel. Disconnecting this harness will cause an

airbag light to illuminate in the gauge cluster which needs to be

reset by a Volkswagen dealership.

1. When making electrical connections it is always recommended that

the vehicle’s battery be disconnected from the electrical system before

performing the installation.

2. Carefully remove the radio from the dash of the vehicle. We recom-

mend the use of Part # GET (when applicable) to remove the radio from

the dash. These tools are specifically designed to be used to remove

Volkswagen radios. This will provide access to the factory radio connec-

tors where you will connect the Neo Gateway harness.

3. Disconnect the factory harness from the back of the radio. Disconnect

the antenna connector from the radio.

4. Connect the 8-Pin iPod docking cable into the first port on the Neo

Gateway furthest away from dipswitches. Carefully run the 11 foot iPod

cable behind the dash to the location where the iPod will be mounted or

stored (for example; the glove box or center console). This location