Panasonic CQ-C1110W Manual Do Utilizador

Página de 13
POWER
MUTE
7
1
APM
BA
N
D
SRC
VO
LUME / PUSH SEL
18
19
CQ-C1110W/C1100W
CQ-C1110W/C1100W
15
E
N
G
L
I
S
H
16
E
N
G
L
I
S
H
Speaker connections
Caution: Please follow the instructions given below.  Failure to do so will cause damage to the unit and
speakers.
L
R
- 
- 
- 
- 
- 
- 
- 
- 
- 
- 
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
L
R
L
R
L
R
<Right>
<Wrong>
(White)
(White
w/black stripe)
Chassis
(Gray 
w/black stripe)
(Gray)
Chassis
• Use ungrounded speaker only.
• The maximum speaker input should be 45 W or more.  (If used with the
optional power amplifier, the speaker input should be higher than the maxi-
mum amplifier output.)
• The speaker impedance should be 4 - 8 
Ω.
• This unit uses the BTCL circuit, so each speaker should be connected sepa-
rately using parallel vinyl insulated cords.
• The speaker cords and the power amplifier unit should be kept away (about 30
cm apart) from the antenna and antenna extension cord.
• Never connect the speaker cord
to the body of the car.
• Do not use a 3-wire type speak-
er system having a common
earth lead.
• Do not connect more than one
speaker to one set of speaker
leads (except for connecting to
a tweeter).
Fuse
Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or con-
necting the unit directly without a fuse, could cause fire or damage to the unit.
If the fuse replacement fails, contact your nearest authorized Panasonic Service Center.
Battery notes
Remove and dispose of an old battery immediately.
Battery Information:
• Battery type: Panasonic lithium battery (CR2025)
• Battery life:
Approximately 6 months with normal use (at room temperature)
Remote control unit
Battery installation
Remove the battery holder.
Pull the battery holder by the position B while pushing
position A in the direction indicated by the arrow.
Install the battery on the battery holder.
Place a battery in the holder with its “+” side facing up
as shown in the figure.
Insert the battery holder.
Push the battery holder back into its original position.
Back side
Lithium battery
Battery holder
Position A
Position B
• Do not disassemble or short the battery. Do not throw a battery into a fire.
• Keep batteries away from children to avoid the risk of accidents.
• Be careful to observe proper local disposal rules when you dispose of batteries.
Control reference guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit’s sensor.
Caution: Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a
fire.
[MUTE]
(Mute)
(
page 6)
[VOL] [VOL]
(Volume )
(
page 6)
[TUNE] [TUNE]
[
TRACK] [TRACK]
(Tune/track selection/track search)
(
pages 8, 11)
PWR
MODE
PRG
TUNE
TRACK
Car Audio
BAND/DISC UP
VOL
MUTE
(ATT)
[PWR]
(Power)
(
page 6)
[MODE]
(Mode (source))
(
pages 8, 10)
[BAND]
(Band) (Pause)
(
page 8, 11)
q
w
e
Only for CQ-C1110W
Note: CQ-C1100W has no remote control function.