JAI TS-2030EN Manual Do Utilizador

 
 

 

 

 

 

 

•  Drive the setup vehicle slowly towards the trigger line through the center of the cameras field 

of view in the same manner (heading) as a typical driver would occupy this lane. 

•  Stop the vehicle approximately one foot (0.3 meter) past the trigger line. Make sure that the 

vehicle is parked aimed in the same direction as the average driver would point their car if they 

were driving through this section of roadway. 

•  To help the driver of the vehicle properly aim the car while driving, instruct him (or her) to 

always look forward down the road as they would normally. Use a sound to signal the driver 

when to stop. 

Using your portable plate stand, position a license plate: 

•  at the minimum expected trigger distance from the camera. 
•  at the minimum expected plate height above the road. 
•  at the location along the trigger line where the center of the horizontal field-of-view of this 

camera is desired. 

Rotate the plate on the stand until the top and bottom edges are level with the vehicle parked 
behind the trigger line (to within a + or – a couple of degrees). Secure the plate on the plate stand 

so that the adjustments you have just made do not change. 

1. Back away all of the thumbscrews on the lens holder until they do not touch the knurled 

adjustment rings on the lens. 

2. Make sure the lens aperture adjustment is fully open (rotate the third ring from the front of the 

lens fully counter-clockwise until it stops at the f1.2 setting). Secure the thumbscrew that lines 
up with the aperture ring until it just presses against the ring. Next tighten the thumbscrew that 
lines up with the knurled ring closest to the camera body until it just presses against the lens. Do 

not tighten any Lens Holder thumbscrews beyond a slight pressure against the lens. 

3. Loosen the roll, pan, and tilt bolts on the JAI camera mounting head until each axis can be easily 

adjusted by hand but any particular setting will stay in place after you let go. 

4. Power on the Setup computer and then start the ENSetup program. Press the “Video Window” 

button to open the Video Window and then select the camera for adjustment from the tree-view 
on the left side of the window. Press the “Live” button in the toolbar to start the video 

streaming. Press the “Tilt Line” button to show the alignment guidelines. The “Tilt Line” can be 
moved using the mouse, or if the “Tilt Line” is selected, using the arrow-keys. 

5. Interactively adjust the roll, pan, and tilt of the camera mount and the lens zoom and focus 

rings: 

6. Adjust the lens focus ring (and camera pan and tilt as necessary) to obtain a focused image of the 

plate on the plate stand. If at any time you cannot fully focus the plate because the focus ring on 

the lens has reached the end of its turning movement, perform the back-focus procedure 
described in the JAI document titled “Zoom Lens Back-Focus Procedure.”