Toshiba IK-WB30A Manual Do Utilizador

17

In this user’s manual, “User” refers to whoever has access to the Network Camera, 
and “Administrator” refers to the person who can configure the Network Camera and 
grant user access to the camera.

Network Deployment is shown in the Quick Start Guide(QSG). Please refer to 14 pages of QSG.

There are several ways to set up the Network Camera over the Internet. The first way is to set 
up the Network Camera behind a router. The second way is to utilize a static IP. The third way is 
to use PPPoE.

Internet connection via a router

Before setting up the Network Camera over the Internet, make sure you have a router and follow 
the steps below.

1. Connect your Network Camera behind a router, the Internet environment is illustrated below. 

Regarding how to obtain your IP address, please refer to Software Installation on page 19 for 
details.

Please  verify  that  your product  package  contains all  the  accessories  listed  in the Package 
Contents listed on  page  13.  Depending on  the  user’s  application, an  Ethernet  cable  may  
be needed.  The  Ethernet  cable should  meet  the  specs  of UTP Category 5. 

Hardware Installation is shown in the Quick Start Guide(QSG). Please refer to 13 pages of 
QSG.

IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1

IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1

LAN (Local Area Network)
Router IP address : 192.168.0.1

WAN (Wide Area Network )
Router IP address : from ISP

Cable or DSL Modem

LAN (Local Area Ne
Router IP address :

WAN (Wide Area Network )
Router IP address : from ISPP

POWER

COLLISION

LINK

RECEIVE

PARTITION

1

2

3

4

5

Internet

This client PC sets up 
a camera and a router.