VIVOTEK IP8372 Manual Do Utilizador

 

 

Connect DI or DO devices to the camera's terminal block, the camera will automatically detect 

the current connection state as pulled-high or pulled-low. You may then define the triggering 

condition. 
Digital input: Select High or Low as the state of the signal to define the "Normal status" for the 

digital input. Connect the digital input lines to the Network Camera, and the camera will report 

the current status.

Digital output: Select Grounded or Open as the state of the signal to define the "Normal status" 

for the digital output. Connect the digital output lines to the Network Camera, and the camera 

will display the current status.

This section explains how to set up camera tamper detection. With tamper detection, the 
camera is capable of detecting incidents such as

 redirection, blocking or defocusing, or even 

spray paint.

Please follow the steps below to set up the camera tamper detection function:

1. Check 

Enable camera tampering detection.

2. Enter the tamper trigger duration. (10 sec. ~ 10 min.) The tamper alarm will be triggered only when the  

    tampering factor (the difference between current frame and pre-saved background) exceeds the 

    trigger threshold.

3. Set up the event source as Camera Tampering Detection on 

Event > Event settings > Trigger. 

Advanced Mode