Canon VB101 Manual Do Utilizador

Click the [OK] button to change the settings. To discard the changes, click the

[Cancel] button. This returns you to the settings title page.

Route settings are required when 
communicating with a wide-area network 
through a router. When using both Ethernet 
and PPP, set the route as needed.

"Default route"
The same setting can be made at "Default 
gateway address" on the Basic Settings 
settings page. Specify the route that 
would normally be used. A gateway 
address is required if a router on the 
Ethernet side is used.

"Route 1-3"
Use this setting if you require connection 
routes other than the normal route. You 
can select either Ethernet or PPP as the 
interface. Specify the destination route in 
the Destination and Mask fields. You must 
specify a gateway address if you are 
using a router on an Ethernet network.

"Send packet regularly"
When this is selected, an ICMP Echo 
packet is transmitted periodically to a 
specified address in order to maintain the 
network connection.

"Target Address"
Specify where the PING should be sent.

"Interval(min)"
In minutes from 1 to 60, specify the 
interval at which PING should be sent.

c