Petsafe PIG00-10773 Manual Do Utilizador

 

www.petsafe.net 21 

Before you begin installing the Boundary Wire, unplug the Fence 
Transmitter power adapter from the Surge Protector or outlet.

Burying the Boundary Wire is recommended to protect it and prevent disabling 
the system.

Cut a trench 

1. 

1-3 inches deep along your planned boundary.

Place the Boundary Wire into the trench maintaining some slack to allow it to 

2. 

expand and contract with temperature variations.
Use a blunt tool such as a wooden paint stick to push the Boundary Wire into 

3. 

the trench. Be careful not to damage the Boundary Wire insulation.

The Boundary Wire of the PetSafe

®

 Deluxe Little Dog In-Ground Fence

™

 can 

be attached to a chain link fence, split rail fence, or a wooden privacy fence. 
The Boundary Wire can be attached as high as needed. However, make sure the 
Boundary Width is set at a high enough range for the pet to receive the signal. If 
using a Double Loop with an existing fence at least fi ve feet tall, run the Boundary 
Wire on top of the fence and return it on the bottom of the fence to get the fi ve 
foot separation needed.

 

Weave Boundary Wire 
through the links or use 
plastic quick ties. 
Wooden Split Rail or 

Privacy Fence (7A):
Use staples to attach 
Boundary Wire. Avoid 
puncturing the insulation 
of the Boundary Wire. 
Double Loop with an 

Existing Fence: Run 
Boundary Wire on top of 
the fence and return

it on the bottom of the fence to get the 5 foot separation needed.

Bury the Boundary Wire in the ground across the gate 

opening. Note: The signal is still active across the gate. Your pet cannot pass through an 
open gate.
Gate (Double Loop) (7B): 

Bury both Boundary Wires across the gate opening 

while keeping them at least 5 feet apart.

7