Petsafe PIG00-10773 Manual Do Utilizador

34 

Please follow these steps in determining where you have a break in your Boundary Wire:

Locate your original splice(s) and verify they have a good, solid connection.

1. 

Check your yard to determine any possible damage to the Boundary Wire (e.g. recent 

2. 

digging, aerating, rodent burrowing, or any other noticeable disturbance in your yard next 
to the Boundary Wire).

If you still cannot fi nd the break in the Boundary Wire, there are two options for locating it:

Option 1: Contact the Customer Care Center to purchase a Wire Break Locator that will 
locate the break in the Boundary Wire.

Option 2: Follow the procedure below:

Unplug the Fence Transmitter.

1. 

Connect both ends of your twisted Boundary Wire to one Loop Wire Terminal.

2. 

Measure and cut a Test Wire which is half the length of your total Boundary Wire footage.

3. 

Connect one end of Test Wire to the other Loop Wire Terminal.

4. 

Locate the halfway point of your boundary and cut the Boundary Wire.

5. 

Splice the other end of the Test Wire to either side of your Boundary Wire where you cut 

6. 

it in half.
Plug in the Fence Transmitter and check the Loop Indicator Light. If the Loop

7. 

Indicator Light glows solid green, you can assume the break is in the other half of the 
Boundary Wire.
If the Loop Indicator Light is off and the alarm sounds, you may assume there is a break 

8. 

in this portion of the Boundary Wire. However, there is a small chance of having more 
than one break in your system. Be sure to check both halves of your entire loop.
Replace the damaged Boundary Wire with new Boundary Wire.

9. 

Reconnect the Boundary Wire to the Fence Transmitter.

10. 

Check the Loop Indicator Light. If the Loop Indicator Light glows solid green, test the 

11. 

system with the Receiver Collar.

This Product is offered to you conditioned upon your acceptance without modifi cation 
of the terms, conditions and notices contained herein. Usage of this Product implies 
acceptance of all such terms, conditions, and notices. 

This Product is designed for use with pets where training is desired. The specifi c 
temperament of your pet may not work with this Product. If you are unsure whether
this is appropriate for your pet, please consult your veterinarian or certifi ed trainer.
Proper use includes reviewing the entire Guide provided with your Product and any 
specifi c Caution statements.

This Product is designed for use with pets only. This pet training device is not intended to 
harm, injure or provoke. Using this Product in a way that is not intended could result in 
violation of Federal, State or local laws.

In no event shall Radio Systems

®

 Corporation be liable for any direct, indirect, punitive, 

incidental, special or consequential damages, or any damages whatsoever arising out of or 
connected with the use or misuse of this Product. Buyer assumes all risks and liability from 
the use of this Product.

Radio Systems

®

 Corporation reserves the right to change the terms, conditions and notices 

under which this Product is offered.