Alpine IVA-D310 Manual Do Utilizador
74
-EN
01GB07IVA310.fm
ALPINE IVA-D310 68-02278Z28-A (EN)
Installing the Tuner Box
When mounting with Velcro fasteners
When mounting the tuner with the Velcro fasteners, be sure to choose a
flat location.
Do not hang the unit from the bottom of the dashboard or rear deck with
the Velcro fasteners.
flat location.
Do not hang the unit from the bottom of the dashboard or rear deck with
the Velcro fasteners.
1
Remove the Protective paper and attach two pieces
of Velcro fastener to the bottom of the Tuner.
of Velcro fastener to the bottom of the Tuner.
2
Check the position, and then fix the Tuner to the
floor carpet.
floor carpet.
When mounting with Screws
When mounting the tuner with the screws, be sure to choose a flat
location.
When making holes, be careful not to scratch any pipes or wires.
location.
When making holes, be careful not to scratch any pipes or wires.
1
Connect the bracket to both the flanks of the tuner
with the supplied pan screws (M4
with the supplied pan screws (M4
× 8).
2
Install the tuner on the floor with the supplied flange-
head tapping screws (M4
head tapping screws (M4
× 14).
Installing the DC/DC Converter
Install the DC/DC Converter on the floor with the
supplied flange-head tapping screws (M4
supplied flange-head tapping screws (M4
× 14).
Caution
Do not block the unit’s fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
<Side of the tuner box>
Tuner Box
Protective paper
Velcro Fasteners
(Included)
(Included)
Protective paper
Tuner Box
Pan screws (M4
× 8) (Included)
Bracket (Included)
Tuner Box
Flange-head tapping screws
(M4
(M4
× 14) (Included)
DC/DC Converter
Flange-head tapping
screws (M4
screws (M4
× 14)
(Included)
01GB00IVAD310.book Page 74 Wednesday, December 1, 2004 4:20 AM