Panasonic BT-LH1850P Manual Do Utilizador

Página de 60
10
11
Controls and Their Functions
Video monitor
Front panel
Rear panel
1
3
2
Rear panel
(→page 12)
Power supply 
(you can switch between AC 
and DC (→page 13)) 
Front panel
(This page)
1   Tally Lamps (Red and Green)
Can be lit by a control signal (red tally and green tally) from 
a GPI/camera.
If the red tally and green tally light at the same time, the tally 
color will become amber.
2   Protective panel mounting screw holes (8 holes)
Eight screw holes have been provided to enable attachment 
of a permanent protection panel. The screws for the protec-
tive panel are installed in the mounting screw holes at time 
of shipment. To attach a protective panel, first remove the 
screws before securing the panel.
<Note>
The LCD panel is shipped covered with a packaging material 
to protect it from damage during unpacking and transporta-
tion.  Remove the panel before using the monitor.
3   Tilt Stand
The tilt stand allows you tilt the unit approx. 10 degrees for-
ward or approx. 15 degrees backward.
When tilting the unit, firmly hold the bottom of the stand and 
move the top of the unit.
If you want to remove the tilt stand, refer to “Detaching and 
Attaching the Tilt Stand” (→page14).
<Note>
• When tilting the monitor, be careful not to trap your hand 
between the monitor and stand.
Front panel
HEADPHONES
VIDEO
SDI 1
INPUT SELECT
SDI 2
HDMI
DVI-I
1
2
FUNCTION
3
VOLUME
PICTURE
4
5
MENU
RETURN
5
6
1
2
3
4
1
  POWER switch
Switches the power supply ON/OFF. When the power is ON, 
the LED (green) lights.
To turn the power off, press and hold the switch for at least 
three seconds.
2
  INPUT SELECT button
Selects the signal input line. The green LED light above the 
pressed button indicates the selected input signal.
VIDEO  : Video input
SDI1 
:  Serial digital interface input (HD/SD compatible)
SDI2 
:  Serial digital interface input (HD/SD compatible)
HDMI  : HDMI input (HDCP compatible)
DVI-I  : DVI-I input (HDCP compatible)
• Selects one of four input signals: digital video or 
PC signal, analog video or PC signal. (→page 38)
• The input line when the power supply is switched ON is the 
one that was selected the last time the power was switched 
OFF.
• When the control lock is on, the 
 mark appears and 
input lines cannot be changed. (→page 41)
• When INT-SG (internal chart for adjustment “Color Bar + 
Grayscale”)  is  selected,  all  LEDs  above  the  INPUT  SE-
LECT button are off.  Use the “INPUT SELECT” menu to 
select INT-SG. (→page 18)
3
  FUNCTION button
FUNCTION1 to FUNCTION5:
Press to use function assigned to the FUNCTION button 
with the menu.
• When the control lock is on, the  
 mark appears to 
indicate that FUNCTION operation is disabled. (→page 41)