Panasonic BT-LH1850P Manual Do Utilizador

Página de 60
14
15
Detaching and Attaching the Tilt Stand
The tilt stand is detachable.
• When detaching and attaching the tilt stand, it is recommended that you place the unit flat on the edge of a desk or table with a soft 
cloth or similar material spread underneath.
Detaching the tilt stand
Tilt stand screws
1. 
Unscrew  the  tilt  stand  screws  (four)  using  a  Phillips 
screwdriver.
2. 
Detach the tilt stand.
• After  detaching,  please  store  the  tilt  stand  and  the  tilt  stand 
screws.
Attaching the tilt stand
A
Tilt stand screws
Plate
1. 
Attach the tilt stand to the unit.
• Insert the plate of the tilt stand into part A (illustrated) of the 
monitor unit.
2. 
Screw the tilt stand to the unit by screwing the tilt stand 
screws (four) using a Phillips screwdriver.
(Screwing torque: Tighten to about 100 N cm or more)
On-screen Display
The screen shows the operation status display, main menu, FUNCTION menu, INPUT SELECT menu, Picture adjusting menu, audio 
volume display, sharpness display, FUNCTION display, audio level meter display, time code (TC) display, closed caption (CC) display, 
in monitor display(IMD) display and other information.
Operating status display
4
1
2
5 6
7
3
P-P FILM
SDI1  1080/60i
 
<Note>
• The  display  state  of  the  status  can  be  set  in  “STATUS  DIS-
PLAY” of the “SYSTEM CONFIG” menu (→page 27).
• “UNSUPPORT SIGNAL” and “NO SIGNAL” may not be prop-
erly displayed.
1. 
The selected input line (→pages 11 and 18)
• Displays  VIDEO,  SDI1,  SDI2,  HDMI,  DVI-I  (YP
B
P
R
/
RGB-COMP./DVI-VIDEO/DVI-COMP.) and INT-SG.
2. 
 Signal format
• “UNSUPPORT SIGNAL” appears if an unsupported signal is 
input. It may also indicate that the format selected in the “IN-
PUT SELECT” menu does not match the input signal.
• “NO SIGNAL” appears when no signal is input.
3. 
 Various indications (PIXEL TO PIXEL mode)
• This indicates the PIXEL TO PIXEL mode is engaged.
4. 
 Various indications (FILM mode)
• This indicates that “GAMMA SELECT” of the “VIDEO CON-
FIG” is set to “FILM.”
5. 
 Various displays (lock setting)
• This indicates that the front operations lock is on. (→page 41)
6. 
Mute indication
• Indicates  that  the  speaker  and  headphones  are  muted. 
(→page 19)
7. 
Picture adjustment change indication
• Indicates that picture adjustments (PEAKING/PHASE/
CHROMA/BRIGHT/CONTRAST/BACKLIGHT) have been 
changed from the values assigned using SETUP LOAD or 
POWER ON SETUP. (→page 19)