Panasonic BT-LH1850P Manual Do Utilizador

Página de 60
16
17
On-screen Display 
(continued)
Time code (TC) display
( : ) NDF
( . ) DF
• Use the menu to display the time code for HD-SDI signal input. 
It  also  allows  you  to  switch  display  mode  (LTC,  VITC,  LUB, 
VUB). (→page 40)
In VITC and LTC display mode:
• Displays the time code as follows.
hours: minutes: seconds: frames
• In drop-frame mode, a different delimiter between seconds and 
frames is used.
<Note>
Read errors are displayed as “--:--:--:--”
In VUB and LUB display modes:
• BG8,  BG7,  BG6,  BG5,  BG4,  BG3,  BG2,  BG1  appear  in  the 
stated order.
BG: binary group
• The (:) delimiter does not appear.
<Note>
Read errors are displayed as “-- -- -- --”
Closed caption (CC) display
display area
Closed caption
display area
Closed caption
(When the specified window extends out of the entire screen)
• Closed caption can be displayed when SDI signals and 
VIDEO signals are input.
• Closed caption complies with the following standards.
• Composite Standard  EIA/CEA-608 (VBI), OP-42
• SD-SDI CC Standard  EIA/CEA-608 (ANC/VBI), OP-42
• HD-SDI CC Standard   EIA/CEA-608 (708), EIA/CEA-708,  
OP-47
• In the case of EIA/CEA-708, multiple windows can be displayed 
at specified positions (up to 8).
• The display position is within a display area that is located in-
side the entire screen. (Refer to the following notes.)
• The display settings can be configured in the menus. You can 
also  select  the  type  of  closed  caption,  display  channel  (EIA/
CEA-608),  and  display  service  (EIA/CEA-708)  in  the  menus. 
(→page 40)
<Note>
• The specified window position is displayed as a position within 
the display area depending on the closed caption information.
• The window may extend out of the display area depending on 
the specified window position and size. In such a case, the win-
dow will be displayed but if the window also extends out of the 
entire screen, the display position of the window will be changed 
so that the window is displayed inside the entire screen.
In monitor display (IMD) display
CAM1
Tally-1
Tally-2
Text
• This monitor supports the TSL UMD PROTOCOL (Ver. 3.1 and 
Ver. 4.0) and allows you to display text and the tally indication 
on the monitor using the RS-485 interface. 
• For information on how to set IMD and communications, refer 
to pages 41 and 46.