Panasonic BT-LH1850P Manual Do Utilizador

Página de 60
24
25
Main menu 
(continued)
VIDEO CONFIG
The underlined values are factory preset setting values.
Sub menu
Settings
Description
GAMMA SELECT 
*
1
*
2
STANDARD
FILM
STDIO/PST
Selects gamma curve.
<STANDARD>  Standard mode (2.2 gamma value)
<FILM>            Film mode
<STDIO/PST>    Color emphasis mode (2.35 gamma value)
• When FILM is selected, the 
 mark is displayed for the operating status.
FILM GAMMA
VARICAM
OTHER
Selects type of FILM gamma mode.
<VARICAM>     For VARICAM use
<OTHER>        Other
(Gamma curve image)
Brightness
Input Level
Video Gamma
VARICAM
OTHER
COLOR TEMP.
USER 0 - 63 
*
3
D93
D65
D56
VAR1
VAR2
VAR3
Selects color temperature.
<USER 0 - 63>   Adjustable settings 0 - 63 
(equivalent to a color temperature range of 3,000 K - 9,300 K)
<D93>     Equivalent to a color temperature of 9,300 K
<D65>     Equivalent to a color temperature of 6,500 K
<D56>     Equivalent to a color temperature of 5,600 K
<VAR1>   WB adjustment mode 
*
4
<VAR2>   WB adjustment mode 
*
4
<VAR3>   WB adjustment mode 
*
4
SHARPNESS MODE 
*
5
HIGH
LOW
Selects the width of outline correction edge.
<HIGH>   Narrow edge
<LOW>    Wide edge
SHARPNESS H 
*
5
0 - 30
Sets horizontal outline correction. The item display moves to the lower part of the 
screen during adjustment.
SHARPNESS V 
*
5
0 - 30
Sets vertical outline correction. The item display moves to the lower part of the 
screen during adjustment.
I-P MODE 
*
6
MODE1
MODE2
Selects IP conversion mode. (see “IP mode” (→page 26).)
<MODE1>    Intra-frame interpolation
<MODE2>    Intra-field interpolation
*
1
 
In split-screen display, changes are not reflected to the still image in the main window.
*
2
 
This menu is grayed out when the same item is assigned to the GPI input terminal pin and GPI CONTROL is set to ENABLE.
*
3
 
When selecting USER 0 - 63
1) Push the rotary knob (USER changes to blue).
2) Use the rotary knob to select 0 to 63 and press the rotary knob.
*
4
 
Selecting “VAR1”, “VAR2” and “VAR3” engages the WB adjustment mode (→page 26).
*
5
 
The following sharpness values are available and the settings for the selected input signal is displayed.
Adjustment status during selection appears at the bottom left of the screen.
1) VIDEO system input (VIDEO) (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0)
2) HD inputs other than (1) above (the factory defaults are SHARPNESS MODE: HIGH and SHARPNESS H/V: 0).
3) SD inputs other than (1) above (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0).
*
6
 
To use the “SUB WINDOW” (→page 34) function, 
1) Change settings after exiting the “SUB WINDOW” function.
2) It is recommended to use “MODE2” for handling fast video.
(Continued on next page)