Peerless Industries PA740 Manual Do Utilizador

ISSUED: 01-27-08   SHEET #: 095-9283-3   06-12-09

Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to 

edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall 

plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) 

deep. Attach wall mount (

A) to wall using two #14 x 2.5" flat head wood screws (H) as shown.

2

WOOD 

STUD

WALL 

PLATE

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all 

attached hardware and components.

•  Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the 

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder 

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations (not UL approved).