Stow 13HP Manual Do Utilizador

Figure 3 displays the location of the various operational control
features of the Cutter 3 Saw. Features are dependent on the specific
model saw selected. The function of each console component or
indicator is explained below:

1.

 Used to steer and push the Cutter 3 saw

during cutting operations. The handle can be folded down
for transportation.

2.

 Controls forward and

reverse speeds for self-propelled operation. Provides
positive neutral for engine start. ALWAYS place
transmission engage/disengage lever in the engage
position before setting speed lever (self-propelled models
only).

3.

 Physically orients saw

(raises or lowers) depending on cranking direction (CW or
CCW). Turning the handle 

clockwise  lowers the saw,

turning the saw counter-clockwise raises the saw.

4.

 Forward

locking position engages transmission. Rear Locking
position disengages transmission from rear axle and
permits "free wheeling" (self-propelled models only).

5.

 A 5-gallon capacity water tank provides water

for the saw blade during wet cutting applications.

6.

  ON position 

opens valve and

permits water to flow from source through saw water hose.
OFF position 

closes valve and halts the flow of water.

7.

Hydraulic Drive Transmission - Controls the saw's
forward and reverse movement by using the

reverse speed lever (Self-propelled units only).

8.

 Covers the saw blade during cutting

operations & allows water hoses to be connected to the
cover for wet cutting.

9.

 Covers the drive shaft belt, engine pulley

and the hydraulic transmission belt (on self-propelled
models only).

10. Drive-Shaft Pulley Guard –

 Covers the drive shaft pulley.

11. Rear Wheels –

 Allows the saw to be rolled across ground.

On self-propelled models, the rear wheels are turned by
the spline gears attached to the hydraulic transmission
system.

12. Pointer Arm –

 

Front pointer wheel assists in straight

tracking. Lifts up for storage and pivots down for use.

13. Lifting Bale Kit –

 

Allows for easy lifting and transporting

the Cutter 3 Saw.

14. Engine OFF Switch –

 

Toggle in either direction to stop

the engine.

15. Wheel Clamp –

 

Move handle down making contact with

wheel to avoid unwanted rolling movement. Lift handle to
release.

16. Throttle Lever – (self-propelled units only) Used to adjust

engine RPM speed (

SLOW or FAST).