Husqvarna 966451906 Manual Do Utilizador

18

 - English

Screw the knee joint and the brake band together 

(see figure 5) using a tightening torque of 1-1.5 

Nm. Place the knee joint with the fitted chain brake 

band in the opening in the clutch cover. The space 

for the spring in the cover must be lubricated with 

grease. See figure 6.

Compress the spring with a wide screwdriver and 

press it down with your thumb. See figure 7.

Fit the cover over the brake spring using 1-1.5 Nm 

tightening torque. See figure 8.

Tighten the brake by using the saw’s hand guard 

as a tool. Mesh with the brake and tighten clock-

wise until the brake is in the off position. See 

figure 9.

NOTE! Make sure the bushings in the kickback 

guard’s attachments are kept in place from the 

inside. See figure 9.

Screw the kickback guard in place and put the 

rocket in position. Position the spring (B) in the 

plastic housing (C) (see figure 10) and press the 

spring against the rocker and then press the plastic 

housing into its groove. Tighten the chain guide 

plate in place. 

Fit the:

•  bar
•  chain
•  clutch shoe
•  cylinder cover

Safety equipment

Fig 6

Fig 7

Fig 8

Fig 9

A

B

C

Fig 10