Hitachi CS 51EAP Manual Do Utilizador

English

ASSEMBLY PROCEDURES

WARNING

Never try to start engine without side case, bar

and chain securely fastened.

1. Pull the front hand guard (2) toward the

front handle to check that the chain brake is

disengaged. (Fig. 2)

Fig. 2

2. Remove guide bar clamp nuts (3). Remove the

side case (4). (Fig. 3)

Fig. 3

3. Install the guide bar (5) onto the bolts (6), then

push it toward the sprocket (7) as far as it will go.

Fig. 4

4. Confi rm the direction of saw chain (12) is correct

as in the fi gure, and align the chain on the

sprocket. (Fig. 5)

Fig. 5

5. Guide the chain drive links into the bar groove all

around the bar.

6. Install the side case (4) onto the bolts (6).

Make sure that the boss of chain tension adjust

bolt (8) fi ts into the hole (9) of the bar. (Fig. 4)

The brake lever (11) of the side case must fi t the

groove (10) on the side of the front hand guard.

Then tighten the guide bar clamp nuts (3) by

hand that allows the guide bar end to move up

and down easily. (Fig. 3)

7. Raise the bar end, and tighten the chain (12) by

turning the tension adjustment bolt (13) clockwise.

To check proper tension, lightly lift up the center

of chain and there should be about 0.02 – 0.04"

(0.5 – 1.0 mm) clearance (14) between bar and

edge of drive link. (Fig. 6, 7)

0.02 – 0.04"

(0.5 – 1 mm)

Fig. 6

Fig. 7

000Book_CS51EAP_US.indb 8

2012/03/19 16:33:40