Jonsered CS 2250S Manual Do Utilizador
KEY TO SYMBOLS
2 – English
Symbols on the machine:
WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator’s manual
carefully and make sure you
understand the instructions before
using the machine.
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
•
Approved protective helmet
•
Approved hearing protection
•
Protective goggles or a visor
Both of the operator
′
s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
one hand only.
Never let the guide bar tip come in
contact with any object.
contact with any object.
Tip contact may cause the guide bar to
move suddenly upward and backward
(so-called kickback), which may cause
serious injury.
move suddenly upward and backward
(so-called kickback), which may cause
serious injury.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
certification requirements for certain markets.
Symbols in the operator’s manual:
Switch off the engine before
carrying out any checks or
maintenance. CAUTION! The
start/stop switch automatically
returns to run position. In order
to prevent unintentional
starting, the spark plug cap must be removed from the
spark plug when assembling, checking and/or performing
maintenance.
carrying out any checks or
maintenance. CAUTION! The
start/stop switch automatically
returns to run position. In order
to prevent unintentional
starting, the spark plug cap must be removed from the
spark plug when assembling, checking and/or performing
maintenance.
Always wear approved protective
gloves.
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must
be worn.
be worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake must be engaged
when the chain saw is started.
when the chain saw is started.
You will find the following labels on your chain saw:
EPA II
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements. Category C = 50
hours, B = 125 hours, and A = 300 hours.
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements. Category C = 50
hours, B = 125 hours, and A = 300 hours.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
control devices and system may be performed by any
nonroad engine repair establishment or individual.
The engine exhaust from this product
contains chemical known to the State
of California to cause cancer, birth
defects or other reproductive harm.