RedMax BCZ2450S Manual Do Utilizador

US-12

BCZ2450S/T

■ STARTING ENGINE

1. Rest the unit on a flat, firm place. Keep

the cutting head off the ground and
clear of surrounding objects as it will
start rotating upon starting of the
engine.

2. Push the primer pump several times

until overflown fuel flows out in the
clear tube. (OP1)

3. Move the choke lever to the closed

position. (OP2)

4. Set the stop switch to the "RUN"

position. Place the unit on a flat, firm
place. Keep the cutting head clear of
everything around it. (OP3)

5. Firmly grasp (a) and (b) with left hand,

pull the starter knob quickly until engine
fires. (OP4)

• Avoid pulling the rope to its end or

returning it by releasing the knob. Such
actions can cause starter failures.

6. Move the choke lever downward to

open the choke. And restart engine.
(OP2)

7. Allow the engine to warm up for several

minutes before starting operation.

.04 in

(1~2mm)

1. When restarting the engine

immediately after stopping it, leave the
choke open.

2. Overchoking can make the engine hard

to start due to excess fuel. When the
engine failed to start after several
attempts, open the choke and repeat
pulling the rope, or remove the spark
plug and dry it.

■ STOPPING ENGINE (OP3)
1. Release the throttle lever and run the

engine for a half minute.

2. Shift the stop switch to the "STOP"

position.

• Except for an emergency, avoid

stopping the engine while pulling the
throttle lever.

■ ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2mm when

measured at the carburetor side end.
Readjust with the cable adjuster as
required. (OP5)

■ ADJUSTING IDLING SPEED (OP6)
1. When the engine tends stop frequently

at idling mode, turn the adjusting screw
clockwise.

2. When the cutting head keeps rotating

after releasing the trigger, turn the
adjusting screw counter-clockwise.

• Warm up the engine before adjusting

the idling speed.