Land Pride RCSM3596 Manual Do Utilizador
10
Section 1: Assembly and Set-Up
RCS3596, RCSM3596, RCS3510 & RCSM3510 Series Rotary Cutters 312-708M
6/26/06
Land Pride
Hitch Assembly
Refer to Refer to Figure 1-1:
1.
Install the offset arms (#2) to the cutter making sure
the pinch decals on the arms are to the top and front of
the cutter and assemble the mounting caps (#5).
Secure with bolts (#7) lockwashers (#11) and nuts (#9).
the pinch decals on the arms are to the top and front of
the cutter and assemble the mounting caps (#5).
Secure with bolts (#7) lockwashers (#11) and nuts (#9).
2.
Assemble the hitch (#1) to offset arms (#2) inserting
the tubes (#6) in the offset arms and secure with bolts
(#8) lockwashers (#12) and nuts (#10).
the tubes (#6) in the offset arms and secure with bolts
(#8) lockwashers (#12) and nuts (#10).
3.
Assemble rod end of cylinder (#3) to hitch lug with pin
(#13). Cylinder’s hydraulic elbows should be facing
away from offset arms.
(#13). Cylinder’s hydraulic elbows should be facing
away from offset arms.
4.
Assemble the lift cylinder (#3) or ratchet jack (#14) to
lift lug on the deck and the rear axle and secure with
pins as shown.
lift lug on the deck and the rear axle and secure with
pins as shown.
Tailwheel Assembly
Refer to Refer to Figure 1-2:
1.
Assemble tailwheel arms (#3) to rear axle with u-bolts
(#7) and flange nuts (#4).
(#7) and flange nuts (#4).
2.
Install tailwheel washer (#2) (larger diameter washer)
on the tire yoke (#1) and insert yoke into tailwheel
arms.
on the tire yoke (#1) and insert yoke into tailwheel
arms.
3.
Place washer (#5) on yoke on top side of tailwheel
arms (#3) and secure with roll pin (#6).
arms (#3) and secure with roll pin (#6).
NOTE: Do not tighten hardware until assembly
is complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 28.
is complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 28.
Tailwheel Assembly
Figure 1-2
Driveline Installation
1.
Attach the slip-clutch end of the driveline to the
gearbox input shaft securely. Make certain that the
slip-clutch is fully onto the input shaft splines. Tighten
the conical dog pin on back side of slip-clutch to 45-50
ft-lb torque.
gearbox input shaft securely. Make certain that the
slip-clutch is fully onto the input shaft splines. Tighten
the conical dog pin on back side of slip-clutch to 45-50
ft-lb torque.
2.
Secure the chain on the driveline to the driveline cone
to restrict outer shield from rotating.
to restrict outer shield from rotating.
20703
Hitch Assembly
Figure 1-1
20702