Husqvarna 115 149727 R01 Manual Do Utilizador

9

ASSEMBLY

1.  Make sure the tension release lever is forward or

disengaged.

2.  Place the belt over the pulley on the deck. Refer to

illustration for proper routing.

3.  Move the tension release arm to the rear and 

engage in the latch.

Rear Of Deck

Idler Pulleys

Outer Pulley

Twist in Belt

Tension Release Arm

1.  Place the deck belt shield on the deck over the

drive pulley and secure with hardware removed 

from steel belt shield.

2.  Place retainer on the outer pulley cover.
3.  Align the tab end of the belt cover into the slot on 

the deck belt shield and the other end over the end

of the outer pulley cover.

4.  Secure with knob.

Retainer

Knob

Outer Pulley Cover

Deck Belt Shield

Belt Cover Tab

 Middle Chute Latch

Temporarily secure the hold down bracket to the

1. 

skid plate, using a bolt and nut from the kit and the

outer hole in the bracket. 

If needed, prop the blower housing up so it sits 

vertically level, but leave no more than an 

1

/

8

" gap 

between the deck and blower housing.

Skid Plate

Back-up Plate

Back-up Plate

Using the back-up plate as a template, drill holes

2. 

in blower housing through the slots on the hold 

down bracket. Drill in the middle of the bracket

slots to allow for adjustment if needed. Remove 

hold down bracket.
Remove blower housing. Place back-up plate

3. 

inside the blower housing, lining up new drill holes 

and back-up plate. Install the hold down bracket by

inserting bolts from the inside, through the blower 

housing and into the bracket slots. Secure with

flange nuts.

Hold Down 

Bracket

Hold Down 

Bracket Hole