Petsafe RFA-67 Manual Do Utilizador

8 

Extra direct burial Boundary Wire can be purchased in 500 foot spools 
at the store where you purchased the kit or through the Customer 
Care Center at 1-800-732-2677.

The table at right indicates the approximate length of Boundary Wire 
needed for a square, Single Loop layout. Length will vary due to the 
amount of twisted wire and layout used.

1/4

415

1/3

480

1/2

590

1

835

2

1180

5

1870

10

2800

__________________________________________________

1. Run the Boundary Wire to the Fence Transmitter through a window, under 

a door, through a crawl space vent, or any other appropriate available access. 
You can also drill a hole through your wall.

2. Strip the ends of the Boundary Wire approximately one-half inch.
3. Insert the Boundary Wires into the Boundary Wire Terminals on the Fence 

Transmitter. Make sure the wires do not touch each other at the terminals.

4. Turn the Boundary Width Control knob to 10. This will set the Warning Zone 

at the maximum width. 

5. Plug the Power Adapter into the Power Jack and a 120-volt outlet.
6. The Power Light and Loop Indicator Lights should come on. If this does not 

happen, see the “Troubleshooting” section.

Lightning strikes within 1-2 miles of your installation can create power current

}

Boundary Width 
Control

Power Light

Loop Indicator 
Light

Boundary Wire 
Terminals

Power
Jack

surges or spikes which may damage your unprotected electronic pet containment system. The LP-4100-1 Lightning 
Protector is designed to protect your In-Ground Fence

™

 from surges or spikes that can reach it via your AC power 

connection and/or your buried Boundary Wire.

You may purchase a Lightning Protection Kit through the Customer Care Center at 1-800-732-2677. The 
Lightning Protection Kit protects the system against surges that travel through the power source and/or the 
Boundary Wire. 

__________________________________________________

Your Receiver Collar comes with short Contact Points. Long Contact Points for pets with 
long or thick hair are available through our Customer Care Center at 1-800-732-2677.  
Tighten the Contact Points using Test Light Tool (5A) one-half turn beyond finger tight. 
Check the tightness weekly. 

This Receiver Collar utilizes a replaceable PetSafe

®

 battery (RFA-67). This unique battery is 

designed to make battery replacement easier and increase water protection. 

To insert the battery, align the symbols on the battery (arrow) and Receiver Collar (triangle) 
(5B). Use the edge of the Test Light Tool to turn the battery clockwise until the arrow lines up 
with the lock symbol on the housing. 

To remove the battery, turn the battery counter-clockwise using the edge of the Test Light 
Tool (5C). DO NOT attempt to cut into or pry open the battery. Be sure to discard the used 
battery properly.

Battery life will vary depending on how often your pet tests the system and receives a Static 
Correction. Check the Receiver Collar every month to ensure the battery is working properly.

A replacement PetSafe

®

 battery (RFA-67) can be found at many retailers. Contact the 

Customer Care Center at 1-800-732-2677 or visit our web site at www.petsafe.net to locate 
a retailer near you.

4

5