Tiger Mowers JD 5085M-105M Manual Do Utilizador

Assembly Section 2-21

Install ½” O-ring breather into butt port of inboard cylinder.   Install fittings in the rod 

end of the cylinder according to the diagram in the Common Parts section.   These 
fittings should be positioned to face the butt end of the cylinder.

Next turn the clevis onto the rod of the cylinder until it is tight against the shoulder 

and lock into place with locking bolt on clevis.   

The inboard cylinder can now be installed into the main frame mast with the pin, 

flat-washer and R-clip as shown below.

Install all fittings in the outboard cylinder and adjust to point towards the butt end 

of the cylinder.   Attach the hoses as specified in the parts book.   Slide the cylinder 
into the draft beam from the outside of the draft beam and attach cylinder to the draft 
beam with clevis pin and rollpins. 

Pull the inboard cylinder poston rod down to the extreme extended position.  Slide the 

draft beam under the cylinder

Using inboard cylinder as a pivot point, slide draft beam under tractor and install draft 

beam pin.  Align hole in draft beam pin with holes in main frame boss and install cap-
screw and nylock nut.