Rhino Mounts 1594 Manual Do Utilizador

1594   01/11

Assembly Section 3-8

© 2011 Alamo Group Inc.

•

Examine the fit between the quick hitch and the
bottom of the attachment bracket. The pins must
extend through the slots in the bottom of the
attachment bracket. The tapered side of each pin
must be firmly wedged against the surface of the
slot on the bottom of the attachment bracket. The
attachment bracket should fit snugly against the
bottom of the loader bracket. If there is a gap of
more than 1/8” or if the pins are not firmly seated do
not use the attachment. Contact your dealer before
using the attachment.

5. On level ground, tilt the attachment down 90 degrees

and lower it to the ground. Lower the loader further to
slightly raise the front of the tractor of the tractor off
the ground. Drive the tractor in reverse while the
attachment is on the ground for 20-30 feet to insure
the attachment does not disconnect. If the
attachment disconnects during this process,
discontinue the use of attachment and contact your
dealer.

1. Adjust front wheel tread setting stops, if necessary, to provide a minimum 3/4” clearance between front

tires and any part of loader with lift cylinders fully oscillated. Be sure lift cylinders are fully retracted.

2. Lubricate all grease fittings with SAE multi-purpose grease.

3. Check hydraulic fluid level in tractor. Fill to recommend level, using oil specified in tractor operator’s

manual.