Rhino Mounts DB150 Manual Do Utilizador

DB150   07/11

Maintenance Section 5-11

©2011 Alamo Group Inc.

Inspect blades before each use to determine that they are properly installed and in good condition.  Replace
any blade that is bent, excessively nicked, worn, or has any other damage.  Small nicks can be ground out
when sharpening.

When sharpening blades, grind each blade the same amount to maintain balance.  The
difference in blade weights should not exceed 1 ounce.  Unbalanced blades will cause
excessive vibration which can damage gear box bearings.  Vibration may also cause
structural cracks in the mower.

Use only original equipment blades on this mower.  They are made of special heat-treated
alloy steel.  Substitute blades may not meet specifications and may fail in a hazardous
manner that could cause injury.

When changing Blades always replace the Blade Bolt & Blade Nut at the same time.  Reuse
of Blade Bolts or Nuts could fail in a harzardous manner that could cause injury. 

Inspect Blades daily for normal wear. If Blades have a notch worn into the leading worn into
the leading edge at the lower bend more htan 1/2” DEEP (due to running in gravel and/or
the ground), REPLACE BOTH BLADES ON THAT CARRIER IMMEDIATELY. Failure to
replace such abnormally worn blades may lead to catastrophic failure of the blade and
ejection of the broken part with tremendous force which may cause bodily injury or death.