Poulan 96042003600 Manual Do Utilizador

MENTS:
•  Depress clutch/brake pedal fully and set parking brake.
•  Place motion control lever in neutral (N) position.
•  Place attachment clutch  in “DISENGAGED” position.
•  Turn ignition key to  “STOP” and remove key.
•  Make sure the blades and all moving parts have completely stopped.
•  Disconnect spark plug wire from spark plug and place wire where it cannot come in contact  

MOWER IS TO BE MOUNTED ON THE TRAC TOR, 

REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS 

(C) FROM TRACTOR AND HOOK THE CLUTCH SPRING 

(Q) INTO THE CABLE GUIDE ON FRONT EDGE OF 

LOWER DASH.

Be sure tractor is on level surface and engage park ing 

brake.
•  Lower attachment lift lever to it's lowest position.

NOTE: Be sure mower side suspension arms (A) are point-

ing forward before sliding mower under tractor.
•  Slide mower under tractor until it is centered under 

tractor. 

• 

ATTACH MOWER SIDE SUSPENSION ARMS (A) TO 

CHASSIS - Position hole in arm over pin (B) on outside 

of tractor chassis and secure with retainer spring.

•  Repeat on opposite side of tractor.

•  Place attachment clutch in “DIS EN GAGED” position.
•  Lower attachment lift lever to its lowest position.
•  Roll belt off engine pulley (M) and belt keepers (G).
• 

Remove retainer spring (K), slide col lar (L) off and push 

housing guide (P) out of brack et.

•  Remove clutch cable spring (Q) from idler arm (R).
• 

Disconnect front link (E) from mower - remove retainer 

spring and washer.

•  Go to either side of mower and disconnect mower 

suspension arm (A) from chassis pin (B) and rear lift 

link (C) from rear mower bracket (D) - remove retainer 

springs and washers. 

•  Slide mower out from under right side of tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE