Poulan 196712 Manual Do Utilizador

MENTS:
 •  Depress clutch/brake pedal fully and set parking brake.
 •  Place motion control lever in neutral (N) position.
 •  Place attachment clutch  in “DISENGAGED” position.
 •  Turn ignition key  to “STOP” and remove key.
 •  Make sure the blades and all moving parts have completely stopped.
 •  Disconnect spark plug wire from spark plug and place wire where it cannot come in contact  
 with 

•      Place attachment clutch in “DIS EN GAGED” position.
•     If equipped, turn height adjustment knob to low 

est 

set ting.

•      Lower mower to its lowest position.
•      Disengage belt tension rod from lock bracket.

02565

•         Remove retainer spring holding anti-swaybar to chas sis 

bracket and dis en gage anti-swaybar from bracket.

•         Remove four retainer springs from front plate assembly 

and remove plate.

•         Remove retainer springs from sus pen sion arms at deck 

and dis en gage arms from deck.

•      Raise attachment lift to its highest position.
•     Slide mower forward and remove belt from electric 

clutch pulley.

•      Slide mower out from under right side of tractor.

Be sure tractor is on level surface and mower suspension 
arms are raised with attachment lift control. Engage park-
 ing brake.
•      Swing anti-sway bar to left side of mower deck.
•      Slide mower under tractor with defl ector shield to right 

side of tractor.

IMPORTANT:  CHECK BELT FOR PROPER ROUTING IN ALL 
MOWER PULLEY GROOVES.  

•      If  equipped,  turn  height  ad just ment knob coun 

ter -

clock wise until it stops.

•      Lower mower linkage with attachment lift control.
•      Be sure belt tension rod is in dis en gaged position.
•      Install belt into electric clutch pulley groove.
•      Place the suspension arms on outward pointing deck 

pins.  Retain with double loop re tain er spring with loops 
up as shown.

•     Install front plate assembly to tractor suspension 

brack ets and retain with single loop retainer springs 
as shown.