McCulloch M40-125 M46-125 M46-125R Manual Do Utilizador
MAINTENANCE
12 – English
Assembly
•
Make sure the cutter centres correctly on the shaft.
•
Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.
should be tightened with a torque of 45-60 Nm.
•
Pull the blade around by hand and make sure it
rotates freely. Test run the machine.
rotates freely. Test run the machine.
Spark plug
•
If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
poorly at idle speed: always check the spark plug first
before taking other steps.
•
If the spark plug is dirty, clean it and check that the
electrode gap is 0.5 mm. Replace if necessary.
electrode gap is 0.5 mm. Replace if necessary.
Adjusting the clutch wire
•
Finely adjust the wire using the adjuster screw.
•
Roughly adjust the cluch wire when the fine
adjustment is not enough.
adjustment is not enough.
•
Extend the wire using the fine adjustment screw.
•
Roughly adjust the cluch wire by attaching it to the
different brackets on the clutch bar. Then adjust the
wire finely.
different brackets on the clutch bar. Then adjust the
wire finely.
Air filter
•
Remove the air filter cover and take out the filter.
•
An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
•
When reassembling, make sure that the filter
completely seals against the filter holder.
completely seals against the filter holder.
Clean the paper filter
•
Clean the filter by knocking the filter against a flat
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
Cleaning the foam plastic filter
•
Remove the foam plastic filter. Wash the filter well in
tepid soapy water. After cleaning, rinse the filter well
in clean water. Squeeze out and allow the filter to dry.
NOTE! High pressure compressed air can damage
the foam. After cleaning the filter should be oiled using
engine oil. Wipe away excess oil by pressing a clean
cloth against the filter.
tepid soapy water. After cleaning, rinse the filter well
in clean water. Squeeze out and allow the filter to dry.
NOTE! High pressure compressed air can damage
the foam. After cleaning the filter should be oiled using
engine oil. Wipe away excess oil by pressing a clean
cloth against the filter.
Oil change
•
Empty the fuel tank.
•
Unscrew the oil filler cap.
•
Place a suitable vessel to collect the oil in.
•
Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. When the machine is tilted,
make sure the air filter always is placed in the highest
position. Ask where you can dispose of surplus
engine oil at your local petrol station.
out through the filler pipe. When the machine is tilted,
make sure the air filter always is placed in the highest
position. Ask where you can dispose of surplus
engine oil at your local petrol station.
•
Fill with new engine oil of a good quality. See
instructions in the section "Technical data".
instructions in the section "Technical data".
Fuel system
•
Check that the fuel cap and its seal are not damaged.
•
Check the fuel hose. Replace if necessary.
NOTICE! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the
piston/cylinder.
type! Use of the wrong spark plug can damage the
piston/cylinder.