McCulloch MC18542LT Manual Do Utilizador

• Raise 

hood.

•  Pull bulb holder out of the hole in the backside of the 

grill.

•  Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

• Close 

hood.

Loose or damaged wiring may cause your tractor to run 

poorly, stop running, or prevent it from starting.
•  Check wiring.  See electrical wiring diagram in the 

Repair Parts section.

• Raise 

hood.

•  Unsnap headlight wire connector.
• 

Stand in front of tractor.  Grasp hood at sides, tilt toward 

engine and lift off of tractor.

•  To replace, reverse above procedure.

The throttle control has been preset at the factory and 

ad just ment should not be necessary. If adjustment is nec-

 es sary, see engine manual.

The choke control has been preset at the factory and ad-

 just ment should not be necessary. If adjustment is neces-

sary, see engne manual.

Your carburetor is not adjustable. If your engine does not 

operate properly due to suspected carburetor problems, 

take your tractor to an authorized service center for repair 

and/or adjustment.

Replace with 20 amp automotive-type plug-in fuse.  The 

fuse holder is located behind the dash.

•  Lift seat pan to raised position.
• 

Disconnect BLACK battery cable first then RED battery 

cable and carefully remove battery from tractor.

•  Install new battery with terminals in same position as 

old battery.

• 

First connect RED battery cable to positive (+) terminal 

with bolt and nut as shown. Tighten securely. Slide 

terminal cover over terminal.

•  Connect BLACK grounding cable to negative (-) ter -

mi nal with remaining bolt and nut. Tighten se cure ly.

•  Lower seat pan.

02602

02603