Ferris Industries 5900646 Manual Do Utilizador
30
www.ferrisindustries.com
TROUBLESHOOTING
While normal care and regular maintenance will
extend the life of your equipment, prolonged or
constant use may eventually require that service be
performed to allow it to continue operating properly.
extend the life of your equipment, prolonged or
constant use may eventually require that service be
performed to allow it to continue operating properly.
The troubleshooting guide below lists the most
common problems, their causes and remedies.
common problems, their causes and remedies.
See the information on the following pages for
instructions on how to perform most of these minor
adjustments and service repairs yourself. If you
prefer, all of these procedures can be performed for
you by your local authorized dealer.
instructions on how to perform most of these minor
adjustments and service repairs yourself. If you
prefer, all of these procedures can be performed for
you by your local authorized dealer.
WARNING
To avoid serious injury, perform maintenance
on the mower only when the engine is stopped
and the parking brake engaged.
on the mower only when the engine is stopped
and the parking brake engaged.
Always remove the ignition key, disconnect
the spark plug wire and fasten it away from
the plug before beginning the maintenance, to
prevent accidental starting of the engine.
the spark plug wire and fasten it away from
the plug before beginning the maintenance, to
prevent accidental starting of the engine.
TROUBLESHOOTING THE MOWER
PROBLEM
CAUSE
REMEDY
Engine will not turnover or start.
1. Parking brake not engaged.
1. Engage parking brake.
2. PTO (electric clutch) switch
2. Place in OFF position.
in ON position.
3. Out of fuel.
3. If engine is hot, allow it to cool, then refill
the fuel tank.
4. Engine flooded.
4. Move throttle control out of CHOKE
position.
5. Fuse blown.
5. Replace fuse.
6. Battery terminals require
6. Clean the battery terminals
cleaning.
7. Battery discharged or dead.
7. Recharge or replace.
8. Wiring loose or broken.
8. Visually check wiring & replace broken or
frayed wires. Tighten loose connections.
9. Solenoid or starter motor faulty.
9. Repair or replace. See authorized service
dealer
10. Safety interlock switch
10. Replace as needed. See authorized
faulty.
service dealer.
11. Spark plug(s) faulty, fouled
11. Clean and gap or replace.
or incorrectly gapped.
See engine manual.
12. Water in fuel.
12. Drain fuel & refill with fresh fuel.
13. Gas is old or stale.
13. Drain fuel & replace with fresh fuel.
Engine starts hard or runs poorly.
1. Fuel mixture too rich.
1. Clean air filter. Check choke adjustment
(throttle control).
2. Spark plug faulty, fouled, or
2. Clean and gap or replace.
incorrectly gapped.
(See engine manual.)
Engine knocks.
1. Low oil level.
1. Check/add oil as required.
2. Using wrong grade oil.
2. See engine manual.
Excessive oil consumption.
1. Engine running too hot.
1. Clean engine fins, blower screen and
air cleaner.
2. Using wrong weight oil.
2. See engine manual.
3. Too much oil in crankcase.
3. Drain excess oil.
Engine exhaust is black.
1. Dirty air filter.
1. Replace air filter. See engine manual.
2. Engine choke control
2. Open choke control.
is in closed position.
Troubleshooting, Adjustment & Repair