Ferris Industries 5900646 Manual Do Utilizador

 1.  Remove the deck drive belt.  See MOWER BELT 

REPLACEMENT sections.

 2.  Remove the clutch anchor bolts (A, Figure 30) that 

fasten the clutch anchor pad to the anchor.

 3.  Unplug the PTO clutch from the wire harness.

 4.  Remove the spring anchor nut (E) and remove the 

belt tension spring (D).

 5.  Drop the belt (H) from the crankshaft pulley and 

around the PTO clutch.

 6.  From the front of the machine, pull the belt 

towards the front while sliding it up and over the 
transmission cooling fans.

 7.  Remove the old belt and replace with a new one.  

Make sure the V-side of the belt runs in the pulley 
grooves.

 8.  Install belt over the transmission cooling fans and 

on the transmission input pulleys (G), around the 
idler pulleys (F & I) and on the crankshaft pulley.

 9.  Reinstall the belt tension spring (D) onto the 

anchor bolt and reinstall the nylon nut (E).

 10. Plug the PTO clutch into the wire harness.

 11. Reinstall the clutch anchor pad and hardware (B & 

A).  Tighten securely.

 12. Reinstall the deck drive belt.  See MOWER BELT 

REPLACEMENT section.

Troubleshooting, Adjustment & Repair