Jonsered LT2220 CMA2 Manual Do Utilizador

Your tractor is equipped with an operator presence sens-

 ing  switch.  When engine is running, any attempt by the 

op er a tor to leave the seat without first setting the parking 

brake will shut off the engine.
• 

Depress clutch/brake pedal into full “BRAKE” position 

and hold.

• 

Place parking brake lever  in “ENGAGED” position and 

re lease pressure from clutch/brake pedal.  Pedal should 

re main in “BRAKE” position.  Make sure parking brake 

will hold tractor secure.

The direction and speed of movement is controlled by the 

motion control lever.
•  Start tractor with motion control lever in neutral (N)  

position.

•  Release parking brake.
•  Slowly move motion control lever to desired position. 

Always operate engine at full speed (fast).
• 

Operating engine at less than full speed (fast) reduces 

the engine's operating efficiency.

•  Full speed (fast) of fers the best mower per for mance.

The cutting height is controlled by turning the height ad just-

 ment knob in desired direction.
•  Turn knob clockwise (

 ) to raise cutting height.

• 

Turn  knob  counterclockwise (

 ) to  lower cutting height.

The cutting height range is approximately 1-1/2"  to 4".  The 

heights are measured from the ground to the blade tip with 

the engine not running.  These heights are ap proxi mate 

and may vary depending upon soil conditions, height of 

grass and types of grass being mowed.
•  The average lawn should be cut to approximately 

2-1/2"  during the cool season and to over 3" during 

hot months.  For healthier and better looking lawns, 

mow often and after moderate growth.

•  For best cutting performance, grass over 6" in height 

should be mowed twice.  Make the first cut relatively 

high; the second to desired height.

MOWER BLADES -
•  To stop mower blades,move attachment clutch switch   

to “DIS EN GAGED” po si tion.

GROUND DRIVE -
•  To stop ground drive, depress clutch/brake pedal into 

full “BRAKE” position..

•  Move motion control lever to neutral (N) position.
ENGINE - 
• 

Move throttle control between half and full speed (fast) 

position.

NOTE:  Failure to move throttle control between half and 

full speed (fast) position, before stop ping may cause engine 

to “backfire”.
•  Turn ignition key to “

STOP

” position and remove key.  

Always remove key when leaving tractor to prevent 

un author ized use.

•  Never use choke to stop engine.

IMPORTANT:   LEAVING THE IGNITION SWITCH IN ANY 

POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY 

TO BE DIS CHARGED, (DEAD).

NOTE:  Under certain conditions when tractor is standing 

idle with the engine running, hot en gine exhaust gases may 

cause “browning” of grass. To eliminate this possibility, al-

 ways stop engine when stopping tractor on grass areas.