Jonsered LT2220 CMA2 Manual Do Utilizador

NOTE: The strap hook must go through the discharge chute 

only. Do not allow the hook to enter the slot in the tractor 

back plate. This will allow the dis charge chute to float with the 

mower deck when moving on uneven terrain.

02306

•  Unfold bag by pivoting front bagger tube all the way 

forward and pressing the bottom vinyl binding onto the 

tube.

• 

Inside the bag, install spreader bars and retainer springs 

onto pins on both sides of bag as shown.

• 

Press the vinyl bindings onto the sides of front bagger 

tube.

•  Slide the bagger dump handle through the hole in the 

bagger top, install the clevis pin 10 x 44mm and secure 

with retainer spring.

•  Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in order 

to use the handle to clear the chute in the event it has become 

clogged.

For proper bag function and appearance, it may be nec-

 es sary to adjust the bagger assembly. There should be 6mm 

(1/4")-9mm (3/8") gap between the bagger top and fender 

and the bagger top surface should be even with the top 

surface of the fender. To adjust bagger position:

•  Slightly loosen the nuts securing the bagger RH and 

LH hor i zon tal adjustment brackets. Loosen only enough 

so the brackets keep their position, but allow them to 

be moved.  

• 

Move the brackets the amount forward or back ward you 

wish the bag assembly to move. Retighten the  nuts 

securely. 

•  Slightly loosen the nuts securing the vertical adjust-

ment brackets. Loosen only enough so the brackets 

keep their position, but allow them to be moved. 

• 

Move the brackets the amount up or down you wish the 

bag assembly to move. Retighten the nuts securely. 

•  Reinstall the bagger as sem bly and check the bagger 

to fender fit.  If necessary, repeat the procedure until 

proper fit is attained.

02

90

5

02

906

02

907