King Kutter 999994 Manual Do Utilizador
FINISHING MOWER ASSEMBLY INSTRUCTIONS
STEP 1
With finishing mower still in crate, lay flat on a level surface. Remove
the top & side sections of the crate, leaving the finishing mower resting
on the bottom section. Set aside PTO shaft.
the top & side sections of the crate, leaving the finishing mower resting
on the bottom section. Set aside PTO shaft.
STEP 2
Insert tail wheel arms as shown in Figure E and tighten both the bolt & jam nut.
STEP 3
Raise A – frame assembly (Fig. A & B, Marked #1) forward and swivel brace
arms (Marked #2) around toward rear of the mower. Hook the brace arms to the
tabs (Marked #3, Fig. C) on the back of the mower with bolts provided.
(Fig. D Fully Assembled.)
arms (Marked #2) around toward rear of the mower. Hook the brace arms to the
tabs (Marked #3, Fig. C) on the back of the mower with bolts provided.
(Fig. D Fully Assembled.)
STEP 4
Tighten all nuts and bolts.
8
Figure A
Figure B