Husqvarna 87521RES Manual Do Utilizador

Read these instructions and this man 

ual in its entirety 

before you attempt to assemble or operate your new lawn 
mower. 

IMPORTANT:  THIS LAWN MOWER IS SHIPPED WITH-
OUT OIL OR GASOLINE IN THE ENGINE.

Your new lawn mower has been as sembled at the factory 
with the ex ception of those parts left unassembled for ship-
ping purposes. All parts such as nuts, washers, bolts, etc., 
necessary to com plete the as sembly have been placed in 
the parts bag. To ensure safe and proper operation of your 
lawn mow er, all parts and hard ware you assemble must 
be tightened se curely. Use the correct tools as nec essary
to ensure proper tightness.

1.    Remove loose parts included with mower.

2.    Cut down two end corners of  car ton and lay end panel 

down fl at.

3.      Remove all packing materials ex cept padding be tween

upper and lower handle and padding holding operator 
presence control bar to up per handle.

4.    Roll lawn mower out of carton and check carton thor-

ougly for ad ditional loose parts.

IMPORTANT:  UNFOLD HANDLE CAREFULLY SO AS 
NOT TO PINCH OR DAMAGE CON TROL CABLES. 

1.    Raise lower handle section to operating position and 

squeeze the bottom ends of  lower handle towards 
each other until the pin in handle can be inserted into 
one of the three height adjustment holes.

2.    Remove protective padding, raise upper handle sec-

tion into place on lower handle and tighten both handle 
knobs.

3.      Remove any packing material from around control bar.

Your handles may be adjusted for your mowing comfort. 
Refer to “ADJUST HANDLE” in the Service and Ad justments 
section of this man ual.

The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automo-tive 
Engineers) code J11940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained 
and corrected in accordance with SAE J1995 (Revision 2002-5).  Actual gross engine power will be lower and is af-
fected by, among other things, ambient operating conditions and engine-to-engine variability.  Given both the wide array 
of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, 
the gas engine will not develop the rated gross power when used in a given piece of power equipment (actual “on-site” 
or net horsepower).  This difference is due to a variety of factors including, but not limited to, accessories (air cleaner, 
exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (tempera-
ture, humidity, altitude), and engine-to-engine variability.  Due to manufacturing and capacity limitations, Briggs & Strat-
ton may substitute an engine of higher rated power for this Series engine.