Husqvarna P 520D Manual Do Utilizador

28 – 

English

The cutting head can be placed in the service position to 
provide easy access for cleaning, repairs and servicing. In the 
service position the cutting unit is raised and locked in the 
vertical position.

1

Position the machine on flat ground. Apply the parking 
brake.

2

Raise the cutting unit halfway.

3

Turn off the motor.

4

Remove the lifting eyes from the cutting unit.

5

Start the engine and lower the cutting unit to the lowest 
position (floating mode). The cutting unit now hangs free 
at the back.

6

Turn off the motor.

7

Remove the service strut from the cutting unit.

If it is the first time the service strut is removed, remove 
the safety strap from the strut and place it in the storage 
compartment under the seat.

8

Fit the service strut to the attachment under the base 
plate. The attachment is highlighted in red.

9

Fit the other end of the strut to the attachment on the 
cutting unit. Remove the pin and slide the strut across the 
shaft which is marked red.

10 Release the pin so that it locks over the shaft. 

11 Start the engine and raise the cutting unit to the service 

position.