Ariens 911153 BR21SP CARB Manual Do Utilizador

GB - 22

See Figure 22.
NOTE: The unit should stop immediately 
when the wheel drive control is released, and 
the unit should not creep forward when the 
wheel drive control is disengaged with the 
engine running. The unit’s forward speed 
should increase as the wheel drive control 
gets closer to the handlebar.
If the unit creeps, decrease traction and 
speed. If the unit does not accelerate 
smoothly or seems to slip under load, 
increase the traction and speed.
NOTE: Before adjusting the wheel drive 
cable, first make sure the area around the 
drive components is free of dirt or debris that 
could prevent the transmission from engaging 
or disengaging properly, and then make sure 
the return spring is connected properly to 
idler arm.
Adjust the wheel drive by adjusting the cable 
on the handlebar. 

IMPORTANT: DO NOT adjust the cable so 
the transmission does not return to neutral 
and stop the unit when the control bail is 
released.

1. Start the engine and slowly squeeze the 

wheel drive control against the 
handlebar and then release the wheel 
drive control.

2. The unit should move forward as you 

squeeze the wheel drive control and 
then stop immediately and not "creep" 
slowly forward when you release it.

1. Move the wheel drive cable adjuster up 

or down the handlebar. See Figure 22.
To increase traction and speed, move 
the cable adjuster down the handlebar.

To decrease traction and speed, move 
the cable adjuster up the handlebar.

2. Check the adjustment and readjust as 

needed.

Figure 21

Connect 
battery 
charger here.

Figure 22

Cable Adjuster