Ariens 932035 - 724 Manual Do Utilizador

GB - 15

1. Choke Closed position: 
chokes off air to engine for 
easier start.
2. Choke Open position: 
allows for normal 
operation.
IMPORTANT: Gradually 
open choke after engine 
starts.

The throttle controls the engine 
speed. To increase or decrease 
the engine speed, adjust to:
1. Fast (normal or warm starts)
2.Part-Throttle
3.Slow (cold weather starts)
4.Stop (engine is off)

The electric starter will start a properly choked 
and cranked engine when the starter button is 
pushed. Refer to Starting and Shut-Off.

When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back 
against starter.

ALWAYS position discharge chute deflector at 
a safe angle before starting engine.
DO NOT throw snow any higher than 
necessary.
Push deflector handle forward or down to 
throw snow lower. Pull deflector handle up or 
to the rear to throw snow higher.
IMPORTANT: If Chute Deflector does not stay 
in set position, adjust as directed in Service 
and Adjustments, or repair before operation.

Discharge chute rotates 220°.
ALWAYS position discharge chute in safe 
direction and angle, away from operator and 
bystanders, before starting engine.

IMPORTANT:  If chute does not stay in set 
position, adjust as directed in Service and 
Adjustments, or repair before operation.
Rotate the Chute with Discharge Chute Crank 
Handle.
IMPORTANT: DO NOT force frozen chute 
controls. Start engine and run for 3-5 minutes 
to thaw. If still frozen, take to warm place until 
controls are free.

The axle lock pin is located on the right wheel 
hub. Moving pin from the hub to the axle shaft 
allows the right wheel to turn freely.

The scraper blade allows the back of the 
housing to keep better contact with the surface 
being cleared. It also prevents damage to the 
housing from normal wear.
IMPORTANT: DO NOT allow Scraper Blade to 
wear too far or Auger/Impeller housing will 
become damaged.

The runners control the distance between the 
scraper blade and the ground. Adjust runners 
equally to keep blade level with the ground. 
Refer to Pre-Start for recommended settings.

To add fuel to fuel tank: 

1. ALWAYS place unit in open or well 

ventilated area.

2. Stop engine and allow to cool.
3. Clean Fuel Cap and surrounding area to 

prevent dirt from entering Fuel Tank. 

4. Remove Cap.

IMPORTANT: DO NOT use gasohol or 
gasoline containing alcohol. See Engine 
Manual for correct type and grade of fuel.

5. Fill fuel tank to within 1/2 in (1,2 cm) 

below bottom of filler neck with unleaded 
gasoline. 

NOTE: 932101 and 309 tank capacity is 1 
gallon (3.8 liters). Tank capacity of other 
models is 3.5 quarts (3,3 liters).

6. Replace Fuel Cap and tighten.
7. ALWAYS clean up any spilled fuel.

1

2

OS1300

1

2

3

4

OL2720

WARNING: AVOID INJURY. Read 
and understand Fuel Safety Rules in 
Safety section before proceeding.