Ariens 920014 COMPACT 24 LE Manual Do Utilizador

GB - 16

When pulled, handle will turn engine over.

DO NOT let handle snap back 

against starter.

To clear the discharge chute:

1. Shut off the engine.
2. Wait 10 seconds and make sure impeller 

blades have stopped rotating.

3. Remove the snow clean-out tool (1) from 

the auger housing and use it to remove 
the clog from the discharge chute.

4. Replace the snow clean-out tool on the 

auger housing.

ALWAYS position discharge chute deflector 
at a safe angle before starting engine.

DO NOT throw snow any higher than 
necessary.
Push deflector handle forward or down to 
throw snow lower. Pull deflector handle up or 
to the rear to throw snow higher.

If Chute Deflector does not 

stay in set position, adjust as directed in 
SERVICE AND ADJUSTMENTS on page 22, 
or repair before operation.

Place deflector into position before operation. 
DO NOT throw snow any higher than 
necessary.
Place deflector remote in a forward notch to 
throw snow lower. Place deflector remote in a 
rearward notch to throw snow higher.

Discharge chute rotates 205°.
ALWAYS position discharge chute in safe 
direction and angle, away from operator and 
bystanders, before starting engine.

 If chute does not stay in set 

position, adjust as directed in SERVICE AND 
ADJUSTMENTS on page 22, or repair before 
operation.

Rotate the chute with the discharge chute 
crank handle.

DO NOT force frozen chute 

controls. If frozen, take to warm place until 
controls are free.

Use the axle lock pin to lock or unlock the 
right or left wheel. Lock both wheels to 
increase traction; unlock one wheel to allow 
for easier turning of the unit.

Unit will not drive with both wheels 

unlocked.

Hand contact with the 

rotating impeller is the most common 
cause of injury associated with snow 
throwers. Never use your hand to 
clean out the discharge chute.

Figure 14

OS8180

1. Snow Clean-Out Tool