Ariens 911111 - SSP 21LM Manual Do Utilizador
GB - 13
911112, 113
To drive forward:
Slowly pull the wheel drive control toward
you until you reach a comfortable ground
speed. Hold the wheel drive control in this
position to maintain the speed.
you until you reach a comfortable ground
speed. Hold the wheel drive control in this
position to maintain the speed.
To stop:
Release wheel drive control.
Release wheel drive control.
Speed Control Knob (91112, 113)
The speed control knob stops the wheel drive
control’s travel which limits the unit’s
maximum forward speed.
Turn the speed control knob
counterclockwise to increase the unit’s
maximum forward speed. Turn the speed
control knob clockwise to decrease the unit’s
maximum forward speed.
control’s travel which limits the unit’s
maximum forward speed.
Turn the speed control knob
counterclockwise to increase the unit’s
maximum forward speed. Turn the speed
control knob clockwise to decrease the unit’s
maximum forward speed.
Fuel Shutoff Valve (91112, 113)
IMPORTANT: The fuel shutoff valve MUST
be in the closed position prior to transporting
the unit.
Open the fuel shutoff valve to operate the
unit. Close the fuel shutoff valve when
storing, transporting or servicing the unit.
be in the closed position prior to transporting
the unit.
Open the fuel shutoff valve to operate the
unit. Close the fuel shutoff valve when
storing, transporting or servicing the unit.
Fuel shutoff valve
open.
open.
Fuel shutoff valve
closed.
closed.
Choke Control (91112, 113)
Move choke lever to the choke position to
start a cold engine.
start a cold engine.
NOTE: The choke will slowly open as the
engine warms.
engine warms.
Ignition Switch (911113)
A removable key
operates the ignition
switch. Turn the key to
the start position (2) to
start the unit. The key
will spring back to the
“RUN” position.
operates the ignition
switch. Turn the key to
the start position (2) to
start the unit. The key
will spring back to the
“RUN” position.
RUN Position (1): All
controls are operable.
controls are operable.
START Position (2):
Starter turns over the
engine.
Starter turns over the
engine.
FILLING THE FUEL TANK
To add fuel to fuel tank:
1. Put unit in open or well-ventilated area.
2. Stop engine and allow to cool.
3. Clean fuel cap and surrounding area.
4. Remove cap.
2. Stop engine and allow to cool.
3. Clean fuel cap and surrounding area.
4. Remove cap.
IMPORTANT: See engine manual for correct
type and grade of fuel.
type and grade of fuel.
5. Fill fuel tank to within 1/4 in. (0.63 cm)
below bottom of filler neck with unleaded
gasoline. See SPECIFICATIONS on
page 25.
gasoline. See SPECIFICATIONS on
page 25.
6. Replace fuel cap and tighten.
7. ALWAYS clean any spilled fuel.
7. ALWAYS clean any spilled fuel.
Figure 9
Figure 10
1
2