Cub Cadet LTX1046M Manual Do Utilizador

Batteries give off an explosive gas 

while charging. Charge the battery in a well 
ventilated area and keep away from an open flame 
or pilot light as on a water heater, space heater, 
furnace, clothes dryer or other gas appliances.

When charging your tractor’s battery, 

use only a charger designed for 12V lead-acid 
batteries. Read your battery charger’s Owner’s 
Manual prior to charging your tractor’s battery. 
Always follow its instructions and heed its warnings.

If your tractor has not been put into use for an extended period 
of time, charge the battery as follows:
1. 

Set your battery charger to deliver a max of 10 amperes.

2. 

If your battery charger is automatic, charge the battery 
until the charger indicates that charging is complete. If the 
charger is not automatic, charge for no fewer than eight 
hours.

Before servicing, repairing, or 

inspecting, always disengage PTO, set parking 
brake, stop engine and remove key to prevent 
unintended starting.

A fuse is installed in your tractor’s wiring harness to protect the 
tractor’s electrical system from damage caused by excessive 
amperage.
If the electrical system does not function, or your tractor’s engine 
will not crank, first check to be certain that the fuse has not 
blown. It is located under the hood, mounted behind the top of 
the dash panel on the support bar.

Always use a replacement fuse with the 

same amperage capacity as the blown fuse.

Never exceed the maximum inflation 

pressure shown on the sidewall of the tire.

Refer to the tire sidewall for exact tire manufacturer’s 
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to mow 
unevenly.

Several components must be removed and special tools used in 
order to change the tractor’s transmission drive belt. See your 
Cub Cadet dealer to have the transmission drive belt replaced.