Jacuzzi Whirlpool Spa Manual Do Utilizador

www.clearcreekspas.com

MAINTENANCE

Automatic Filtration/Maintenance

If you plan to be away, minimum water quality will be maintained by running the filter system.

If you will be away for an extended period, however, we recommend that you drain the spa (following the procedure

described under Winterizing on this page), as long periods without maintenance of water quality could be detrimental

to the spa.

Another means of maintaining minimum water quality while away for less than two weeks is to follow the procedure

outlined for winterizing your spa in a warm climate. (Refer to Winterizing.)

NOTE: We do not recommend using this procedure if you are absent during the summer, when algae buildup

is most likely.

Always keep your spa covered when not in use to reduce heat loss and evaporation and to prevent debris from

falling in.

Winterizing

In a climate where winter temperatures are below

freezing, follow this procedure when the spa will

NOT be used:
1. Turn OFF power to the unit at the main electric panel.

2. Drain the spa completely by attaching a garden hose

to the drain valve on the suction plumbing. Then

remove the hose and leave the drain valve open to

completely drain the spa.

3. Remove, clean and store the filter cartridges, in a dry

location.

4. Keep water and debris out by covering with a spa

cover.

Before using the spa again, review the Operating

Instructions.

NOTE: In a warm climate where there are occasional

freezing temperatures, your spa is automatically

protected against freezing. Whenever water tem-

perature falls below 40°F, the pump will activate to

circulate water until the temperature reaches 45°F.

To maintain water quality adjust temperature setpoint to

the minimum setting (80°F), and select ECONOMY

mode.

Factory Installed Redwood Skirt

Your spa is supplied with a factory-installed red-

wood skirt which completely surrounds the spa. The

door can be opened for maintenance.

The skirt is made of kiln-dried redwood and can be

left natural to weather, or you may choose to apply a

stain or clear finish. Consult your local paint dealer for

the appropriate product.

NOTE: We recommend a water based material. Oil

or solvent based finishing materials will degrade the

skirt backing material.

If it becomes necessary to remove one or more of

the skirt panels for major service access, simply remove

the screws with which the section is secured.

To detach any of the panels, first remove all screws

from the panel being detached.

The panels can be reattached to the spa by revers-

ing the above procedure.

NOTE: When you remove the skirt, you will notice

the plastic covered foam insulated batts. These

batts are designed to be removed when service is

required and reinstalled when service has been

completed.

PHILLIPS

SCREWS SKIRT