Jacuzzi J - 480 Manual Do Utilizador

Página de 104
Page 69
J-400
To drain your spa, perform the following steps:
1.  Turn off power to spa at breaker.
2.  Locate the drain valve located on the front left 
corner on the black plastic pan. Hold the 
larger (rear) drain valve body to prevent it 
from turning, then loosen and remove the 
front cap to expose the underlying male hose 
threads.
3.  Attach a garden hose to the exposed threads.
4.  Gently rotate the larger (rear) valve body 
1/3 turn counterclockwise to unlock the drain 
valve.
5.  Pull the larger (rear) body outward as shown 
to open drain.
6.  After the spa drains, perform steps 2-5 in 
reverse order to close the drain prior to refilling 
spa.
  After refilling, turn on power to the spa and follow the steps listed under 
“Spa Fill Up Procedures.” (page 17). Always fill your spa through both 
filter buckets.
14.3  Cleaning the spa Interior
To preserve the sheen of your spa’s surface, it is crucial that you avoid 
using abrasive cleaners or cleaners which have adverse chemical effect 
on the surface. If you are not certain as to the suitability of a particular 
cleanser, consult your authorized Jacuzzi dealer. Regardless of the 
cleanser used, use extreme care to assure that no soap residue is left on 
the surface. This could cause severe sudsing when the spa is refilled. 
14.4  Pillow Care
Clean the headrests in your spa as needed by wiping them with a 
cloth with soapy water. It is not necessary to remove the headrests for 
cleaning. To remove headrests for long term storage or replacement, 
grasp both ends of each headrest and gently pull inward towards the 
center of the spa. To reinstall, over mounting strip and press down until 
headrest mounting bracket emits a “click” sound. Then adjust headrest 
height by simply moving up or down as desired.
14.5  maintaining the synthetic Cabinet
The synthetic cabinet requires little or no maintenance of any kind. To clean, 
simply wipe cabinet with mild detergent soap solution and a clean towel.
14.6  Cleaning the Control Panel
To clean, simply wipe cabinet with a micro-fiber cloth that is used for 
cleaning polycarbonate lenses.
2.
3.
4.
Unlock
Drain
Open Drain
5.