Jacuzzi J-220 Manual Do Utilizador

Página de 43
Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa!  The following is a list 
of automated functions performed by your spa.  These functions are listed below 
in an attempt to suppress any operational concerns you may have during the first 
24-hours of ownership!  Also listed below are important maintenance recommen-
dations you should observe on a regular basis to protect your new investment.
Automated Operations
Approximately two minutes after power is applied to the spa, the first skimming/
heating cycle turns on pump 1.  In J-230 models, an automatic five minute “blow-
out” function also activates pump 2 for a period of five minutes to flush all lines. 
Then, after five minutes, pump 2 turns off and pump 1 continues to operate for 
the duration of the cycle. Note: this function only occurs during the first filtration/
heating cycle each day.
   
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters as 
defined by the Association of Pool And Spa Professionals/USA:
Always maintain your spas filter as outlined below to ensure healthy spa water. 
Refer to page 27 “Water Quality Maintenance” for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that provides 
unsurpassed water quality!  To ensure maximum water quality at all times, you 
should clean the filter cartridge every three months, or earlier as necessary. See 
page 24 for detailed filter cartridge cleaning/replacement instructions.
Required Water Replacement
You should replace the spa’s water every 3 months.  The frequency 
depends on a number of variables including frequency of use, number of users, 
and attention paid to water quality maintenance.  You will know it is time for a 
change when you cannot control sudsing and/or you can no longer get the normal 
feel or sparkle to the water, even though the key water balance measurements 
are all within the proper parameters.  See page 27-28 for additional information.
pH
7.2 - 7.4
Free Chlorine
3-5 ppm
Free Bromine
4-6 ppm
Total Alkalinity
100-120 ppm
Calcium Hardness
150-250 ppm