Homelite HL80215 Manual Do Utilizador

Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is 
sufficient to inflict serious injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1. Failure to do so could result in 
objects being thrown into your eyes resulting in possible 
serious injury.

Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of  
attachments or accessories not recommended can result 
in serious personal injury.

Never direct a water stream toward people or pets, or 
any electrical device. Failure to heed this warning could 
result in serious injury.

You may use this product for the purposes listed below:


Using cleaning deck: removing dirt and mold from decks 
and cement patios



Using spray wand: cleaning cars, boats, motorcycles, 
outdoor furniture, grills, and house siding

See Figure 9.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage 
the pump. Many detergents may require mixing prior to use. 
Prepare cleaning solution as instructed on the solution bottle.


Disconnect pressure washer from power supply.



Place pressure washer upright on a flat surface.



Remove cap from detergent tank.



Pour detergent into tank until it reaches the maximum fill 
level located on the unit.

 

NOTE:  Use  a  funnel,  if  needed,  to  prevent  accidental 
spilling of the detergent outside the tank. If any detergent 
is spilled during the filling process, make sure the unit is 
cleaned and dried before proceeding.



Reinstall cap.

Do not run the pump without the water supply connected 
and turned on.



Connect the garden hose.



Turn the garden hose on then squeeze the high pressure 
trigger to relieve air pressure. Once a steady stream of 
water appears, release the trigger.



After ensuring the On/Off switch is in the 

OFF ( O ) posi-

tion, connect the pressure washer to the power supply.

 

NOTE: For ease of use during operation, you may thread 
the electrical cord through the coils of the garden hose 
before connecting to power supply.



Press the reset button on the pressure washer’s plug to 
make sure the unit is ready for operation.



Press 

ON ( I ) on the switch to start the motor.



To  stop  the  motor,  release  the  trigger  and  press 

( O ) on the switch. 

Hold the handle and wand securely with both hands. Ex-
pect the trigger handle to move when the trigger is pulled 
due to reaction forces. Failure to do so could cause loss 
of control and injury to yourself and others.

See Figure 12.
For  greater  control  and  safety,  keep  both  hands  on  the  

trigger handle at all times.


  Pull back and hold the trigger to operate the pressure 

washer.



  Release the trigger to stop the flow of water through the 

nozzle.

To engage the lock-out:


  Push up on the lock-out until it clicks into the slot.

To disengage the lock-out:


  Push the lock-out down and into its original position.

For the most effective cleaning, the spray nozzle should be 

between 8 in. and 24 in. from the surface to be cleaned. If 
the spray is too close it can damage the cleaning surface.